Search found 411 matches

by Horseman
Fri Jan 23, 2009 10:35 pm
Forum: All other Lee Equipment discussion
Topic: Lee Casting Equipment
Replies: 7
Views: 3142

The Lee casting equipment will work just fine. Get the 20 lb bottom pour pot. The six hole molds are good. I have several of them and they make just as good a bullet as my lyman and RCBS molds. They do take a little prep work before you cast with them, but follow the instructions and you'll be fine....
by Horseman
Fri Jan 23, 2009 10:25 pm
Forum: All other Lee Equipment discussion
Topic: Lee Sizing kits
Replies: 10
Views: 4045

I've used a Star lubrasizer for years and most will tell you it's probably the best type of luber for the home caster. Reason is the nose first type system. Well, that said, Lee also uses the nose first system and they've worked well for me also. I just wasn't to sure about the alox lube. You know, ...
by Horseman
Fri Jan 23, 2009 8:51 pm
Forum: Load Master forum
Topic: Loadmaster arrival
Replies: 7
Views: 2667

daboone wrote:Do ya want to sell the 45 shell plate?

daboone

Hilo, HI
Phoenix, AZ


Sure, I have no use for it or the 9mm plate. I need the 1s and 11l. 357-both 44 mag and spl and 45 colt. At least for now.
by Horseman
Fri Jan 23, 2009 3:32 pm
Forum: Load Master forum
Topic: Loadmaster arrival
Replies: 7
Views: 2667

Loadmaster arrival

Purchased a used loadmaster from a fella for 50 bucks, pretty much complete with powder measure, shell feeder, two bullet feeders that haven't been used ( I can tell, no mashed parts) bags of extra primer parts, myriad of other little extra parts, thank goodness for an extra index rod flipper. Two s...
by Horseman
Mon Jan 19, 2009 4:44 pm
Forum: Load Master forum
Topic: Loadmaster footprint
Replies: 3
Views: 1745

Re: Loadmaster footprint

[Hi Horseman, I really don't know how you'll set it at an angle because the front mounts of the press come up all the way to the edge of the bench. From the centerline of the front bolt hole(s) to the edge of the mount, it's only 3/8" so canting the press at an angle will put one of your bolts ...
by Horseman
Sun Jan 18, 2009 4:58 pm
Forum: Load Master forum
Topic: Loadmaster footprint
Replies: 3
Views: 1745

Loadmaster footprint

Hello all, just purchased a used Loadmaster and waiting for shipping. Meanwhile making room on my reloading bench for it. I want to set this press at a bit of an angle but don't have the footprint measurement. Would one of you be so kind as to check the width for me. I'm guessing it's about 6 inches...

Go to advanced search