Sizing boolits & gas checks/swaging brass base too.

Discussions of bullet casting, sizing, etc.

Moderator: darwin

Posts: 1976
Joined: Fri Oct 26, 2012 9:52 am

Sizing boolits & gas checks/swaging brass base too.

Postby carload9 » Mon Mar 30, 2015 9:27 am

For those who love pre-prep:
GO WITH SOLID TABLES/SHAKE BRAKE/BOLT TABLES TO FLOOR/ARBOR PRESS (1 ton arbor at Harborfreight is $53 out the door).

1) size boolits 380/9/45/45c/& my favorite 38 dwn to 9.
2) seating gas checks on all above .
3) Swaging brass bases' of all above (one die soaking).
4) just spin lee die plate around and go.
5) my MMLLM w/shake brake is next to this arbor press.


1)long tube boolits drop dwn in can.
2)When iam doing brass l just slide the yellow container under drop tube.
3) put longer blk lever on and let it hang down, easy on shoulder.
4)800lb steel table, that leg is bolted to floor, took 30mins to drill concrete.

brevity&misspelling rampant

Return to “Bullet casting”

Who is online

Users browsing this forum: No registered users and 5 guests