rowe_s wrote:When I first got my LM I had some of the problem you are describing. I did the folowing.
1. debured all the plastic parts.
2. moved the sizing die to station two.
3. did carier ailnment again.
I watched closely as the shells entered the dies. They were moving as not in ailingment. I loosened the carier with the shells in the dies so it would line itself up that way, then tightened the carier bolt. Worked ok after that.
Wish I would have writen down the steps after getting it done. I'll have to do it again someday and wish I had good notes. But this describes my method as close as I can remember. (Another bad part of getting old.)
I tried to do something like this , this weekend . Best I remember , when the ram is at the top , I could not get a wrench on the bolt head at the bottom of the ram ? It was blocked by the end of the handle / lever ?
My first idea was to use a ratchet , socket and an extension of appropriate length ?
Any and all advice would be appreciated ?