http://forums.loadmastervideos.com/foru ... .php?t=198
Mike, I ran into a similar problem when I first set-up my press. Primers were going in side ways and frankly, I was wondering if I made the right decision on my new purchase. After re-watching the videos (the one on primer theory) I removed the turret and slooooowly raised the ram. I discovered I was getting jerky primer lever movement. I disassembled the thing and discovered the flash/mold marks on the slider were hanging it up just a little bit. I lightly slid it back and forth a few times on 400 grit paper to where I could not feel any sort of catching. It has worked perfectly since. It doesn't take much to get that jerky movement, which will definitely flip the primers. Also, are you sizing in station 2? That will improve primer feeding immensely.
This forum is for links to threads that offer a definitive fix for a specific Load Master problem. Please post each link separately with a portion of a message that describes the problem or fix. If you want to discuss the issues further, please do so in the original threads.
1 post • Page 1 of 1
Who is online
Users browsing this forum: wcweir3 and 1 guest