Too Much Torque!!

Questions and discussions and troubleshooting Lee Load Master presses

Moderator: darwin

john127
Posts: 118
Joined: Fri Feb 15, 2008 3:44 am

Too Much Torque!!

Postby john127 » Thu Jun 02, 2016 7:16 pm

Thought I'd post a pic of what happens to the yoke on the LLM when it's over torqued. Just recently replaced the warped part with a new one & the press works much smoother now.

I used a Harbor Freight torque wrench (the 1/4" drive that torques in in-lbs) & either Lee's torque values are way too high or the torque wrench is not calibrated correctly. Probably a combination of both.

Image

Return to “Load Master forum”

Who is online

Users browsing this forum: No registered users and 5 guests