Questions and discussions and troubleshooting Lee Load Master presses
4 posts • Page 1 of 1
Where are we getting replacement primer sliders for the older style priming set up. I just installed my last replacement. I see a Large set up on one of the 3D printing sites but not a small primer set up.
GhostlyOne wrote:Actually, my advice to you would be to go to Mike's Reloading bench and invest in his ARS system. Ordering replacement sliders from him is child's play.
Excellent advice! Although I'm not sure Mike offers that service any more.
It would be worth your time to check with him & see. If not, it would be worth your time to talk with Mike about your problem. He's a retired engineer & has devoted a lot of time to understanding the LLM & its problems.
Who is online
Users browsing this forum: No registered users and 18 guests