Page 1 of 1
Posted: Mon Aug 01, 2011 8:55 am
A cousin of mine is asking about installing a case feeder , via " field engineering " , on a Lee Cast iron turret press ?
I can not see a way to make this work ?
Ideas , comments ?
Posted: Sun Aug 21, 2011 1:49 pm
I suppose it could be done but I really don't understand why anyone would want to. The Pro 1000 and loadmaster are the way to go if you want a casefeeder. But it would still be an interesting engineering project. If you do figure it out I would like to see a picture.
Posted: Sun Aug 21, 2011 3:11 pm
He already has the cast iron Lee turret press .
I told him I did not think it would be practical , even if it could be made to work . Would involve " jumping through too many hoops " .