Case Stuck on Decapping / Sizing Pin (.223)

Questions, troubleshooting and tips relating to Lee turret presses

Moderator: darwin

Posts: 332
Joined: Fri Sep 10, 2010 7:59 pm

Postby motopic » Thu Oct 25, 2012 9:08 am

top of the rod(OP calls pin), flush with the top of the top clamp nut.

if you set it with the rod poking up too much, then you are trying to get the ball+brass into the neck portion of the sizer and its never gonna work, it will always jam.

lee dies (esp my 223 dies) want lube on the inside of the neck, I found that a tiny bit of lee lube inside every 3rd or 4th case keeps the expander from dragging on the neck at extraction. If it drags it will affect the case length.

Return to “Turret presses”

Who is online

Users browsing this forum: No registered users and 1 guest