carload9 wrote:Well ya have 4 holes. Powder thru funnel would be me, but iam askin for op. Off press prep work and such. But waiting for answer, of some one who does it.
I used to do them on a Lee 3 hole turret press. a lot of people do different prep work. (Still do the same prep work with the Load-Master.)
This is what I did with the 3 station press.
1. Clean brass
2. Lube brass.
3. Run through full length sizing die with expander/decapper removed.
4. Run cases through case cleaner with media to remove the lube.
5. Use a Lee neck-sizing die to deprime the case and expand the neck.
6. Trim to length.
7. True, swag, and chamfer primer pocket.
3 station turret press was setup this way.....
station 1 = Lee neck-sizing die.
station 2 = powder measure with double disk kit. (very accurate with ball powder)
Station 3 = Dead Length Bullet Seating Die.