Page 1 of 1

.308 Rifle Die Question

Posted: Sat May 07, 2016 3:04 pm
by Jim_Duncan
Lee Deluxe .308 die set. The Neck sizing die has a loose decapping neck sizing pin. Wiggles. Took it apart found nothing obvious... it just wiggles a bit. Seems to operate ok... but never had a decapping pin wiggle before? Anyone else run across this?

Re: .308 Rifle Die Question

Posted: Sat May 07, 2016 9:13 pm
by rowe_s
Jim_Duncan wrote:Lee Deluxe .308 die set. The Neck sizing die has a loose decapping neck sizing pin. Wiggles. Took it apart found nothing obvious... it just wiggles a bit. Seems to operate ok... but never had a decapping pin wiggle before? Anyone else run across this?

I have had a lot of Lee Neck Sizing Dies. Your die does not have a problem. The part that is wiggling is the Shank on the decapper. You can bet when that die clamped up doing it's thing there is no play.