Thought I'd post a pic of what happens to the yoke on the LLM when it's over torqued. Just recently replaced the warped part with a new one & the press works much smoother now.
I used a Harbor Freight torque wrench (the 1/4" drive that torques in in-lbs) & either Lee's torque values are way too high or the torque wrench is not calibrated correctly. Probably a combination of both.
Questions and discussions and troubleshooting Lee Load Master presses
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests