Where is everyone?

Questions and discussions and troubleshooting Lee Load Master presses

Moderator: darwin

User avatar
Site Admin
Posts: 1875
Joined: Mon Jan 28, 2008 8:11 am
Location: Central Indiana

Where is everyone?

Postby darwin » Sun Jan 13, 2019 1:14 am

No posts or comments since December 17. Is the board still working?

Posts: 1
Joined: Tue Dec 18, 2018 2:04 pm
Location: Southern Illinois

Re: Where is everyone?

Postby Dux4life » Sun Jan 13, 2019 12:15 pm

I'm new and trying to research this thing as much as possible. That said no major issues with 9mm or .45. Lots with .40. Waiting on new small primer feed from Lee.

Posts: 59
Joined: Thu Dec 31, 2015 5:39 pm

Re: Where is everyone?

Postby gooffeyguy » Sun Jan 13, 2019 5:26 pm

It's working! I check for new posts every couple of days and haven't seen much activity over the holidays.

Posts: 2
Joined: Sun Jan 20, 2019 7:14 pm

Re: Where is everyone?

Postby Bensjamming » Mon Jan 21, 2019 1:22 am

Also new here and finally got my setup going. Will be asking some questions soon I'm sure.

Posts: 422
Joined: Sun Jan 18, 2009 4:50 pm

Re: Where is everyone?

Postby Horseman » Thu Jan 24, 2019 5:44 pm

I stop in every few days to see if anything is going on. I did start a topic a while back about a new LM I purchased and issues were nill. I alluded to that and that perhaps that was a new "normal" so either the problems of the past have been addressed or new users just aren't familiar with this site...???

I'll just throw this in here for information, I just ran over a thousand 9mm cases through my LM as a depriming machine using a universal depriming die and the "new" universal case feeder. Case feeder worked just fine, had three or four cases fall sideways on the ramp but I was running the press much faster than if I were loading rounds (the case slider when operated fast will really zing those little 9 cases) and I had a couple upside down in the tubes. I'd say that was pretty good considering the amount and speed of operation. No issues with the press itself at all. Well, not true, I ran so many cases that I forgot to empty the ram of spent primers and that jammed it. Didn't notice until the ram wouldn't raise all the way to the top and saw spent primers piling up around the frame.....but that wasn't the presses fault. If interested I'll give a further review of this press when I start loading those cases. But that will probably be awhile, as I have several thousand already loaded. By the way I've owned and operated many of these so I'm not new to the LM.

Posts: 422
Joined: Sun Jan 18, 2009 4:50 pm

Re: Where is everyone?

Postby Horseman » Tue Jan 29, 2019 4:47 pm

Interesting part here is that every time I visit to look for new items being mentioned, and there isn't any, I look down at the bottom of the page and there's always at least 15 visitors on the site. None registered. To bad the "visitors" aren't registering and join in.

Return to “Load Master forum”

Who is online

Users browsing this forum: No registered users and 11 guests